Date:         Wed, 1 Jul 2015 09:09:39 -0400
Reply-To:     george jannini <georgejoann@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         george jannini <georgejoann@GMAIL.COM>
Subject:      Re: Propane and refrigerator success
Comments: To: Neil N <musomuso@gmail.com>
In-Reply-To:  <CAB2RwfjZLmU=HLETTMAOu=3CnaL9-gpSd9shV2xfqc6cRH0N2w@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8

Yep, Neil, was screw loose.


G.

On Tue, Jun 30, 2015 at 6:23 PM, Neil N <musomuso@gmail.com> wrote:

> There should be a screw to hold the element
> in place. Image of 182A 1 pc. elements: http://tinyurl.com/pvkoum6
> The screw doesn't have to be super tight; the outer metal
> of the heating element(s) is relatively thin. It may
> be that there is a dimple at the element for screw to seat in.
>
> On that note, i recall reading of someone
> shimming the element so it would contact the tube as
> much as possible. But then the
> internet is full of "information". IIRC, I hammered
> a piece of brass flat and shimmed the element at the screw side
> of tube.
> I doubt doing this helped improve cooling though.
>
> Neil.
>
> On 6/30/15, george jannini <georgejoann@gmail.com> wrote:
>
> > I probably have checked the heating element for fitment, the 12 volt
> > element was loose enough to slide up and down the tube it's in.
>
>
> --
> Neil n
>
> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
>
> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
>
> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>
>
> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>
>