I use the Aeroquip socketless hose with the push on fittings and use flare fittings with pipe threads for the hose to copper connections. Dennis
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Richard Koller Sent: Wednesday, July 8, 2015 4:29 PM To: vanagon@GERRY.VANAGON.COM Subject: oil cooler set up Dennis, I'm presuming you are attaching short sections of the 1/2 inch ( AN8 ) rubber hoses to the cooler inlet and outlets and thermostat inlets and outlets and then attaching the copper tubing to the ends of the rubber hoses in the mid section from the front to the engine. If this is correct, how do you form a tight seal with the copper and rubber hose connections? Thanks, Rick Koller |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.