Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2015, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 8 Jul 2015 16:28:38 -0400
Reply-To:     Richard Koller <brvkoller@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Richard Koller <brvkoller@GMAIL.COM>
Subject:      oil cooler set up
Content-Type: text/plain; charset=UTF-8

Dennis, I'm presuming you are attaching short sections of the 1/2 inch ( AN8 ) rubber hoses to the cooler inlet and outlets and thermostat inlets and outlets and then attaching the copper tubing to the ends of the rubber hoses in the mid section from the front to the engine. If this is correct, how do you form a tight seal with the copper and rubber hose connections? Thanks, Rick Koller


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.