Date:         Wed, 22 Jul 2015 11:05:42 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: FTE Brake Master Cylinder: Failing Seal? PICS
Comments: To: Jim Felder <jim.felder@gmail.com>
In-Reply-To:  <CAFnDXk0MNy-ioM0PHKQWaL=BEFmsedeho=u3AuhuHxH_5G2uuw@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8

Great tip. Yes, it may apply. I gotta write this stuff down!
I always apply a little antiseize to the outer 1/2 of bleeder
screw threads on any new caliper or wheel cylinder.

But here's what I don't understand:

with, say, a caliper, can air get into the caliper when fluid is being
pushed out
bleeder?

On 7/22/15, Jim Felder <jim.felder@gmail.com> wrote:

> Not sure if this directly addresses your question, but it helps when
> bleeding brakes to surround the bleeding nipple with grease. Vaseline will
> do. This way you know when the nipple is cracked that no air is getting in
> the line through the threads.
>
> Jim
>
> On Wed, Jul 22, 2015 at 3:56 AM Neil N <musomuso@gmail.com> wrote:

>> ....  I was pushing
>> slightly downward on wrench),
>> a HUGE stream of bubbles would flow down the hose to the bottle full of
>> BF.
>> That bleeder screw feels like it has a LOT of play at threads.



--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>