Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2015, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 6 Aug 2015 18:26:25 -0400
Reply-To:     Jack Reynaert <jack007@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jack Reynaert <jack007@COMCAST.NET>
Subject:      Re: No ignition on restart after 5 to 10 mile drive in 90+F
              weather
Comments: To: john <john@JHL.MGACOXMAIL.COM>
In-Reply-To:  <1438824852.2662.13.camel@jhl.mgacoxmail.com>
Content-Type: text/plain; charset="UTF-8"

Had the same issue with my 84 Westy... somewhat consistent... since 1987 when I purchased it. It would always push start however! Tried everything under the sun without resolution, went away after replacing the motor with a 2.1l :) Sure wish I had the advice of this "list" back then.

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of john Sent: Wednesday, August 5, 2015 9:34 PM To: vanagon@GERRY.VANAGON.COM Subject: No ignition on restart after 5 to 10 mile drive in 90+F weather

A gremlin from the past seems to have reappeared on my '84 Vanagon (1.9L) engine. It started the other day after I went to move my van after bringing my Son home from high school (10-mile round trip plus plenty of waiting time in traffic at high school).

Engine turns over fine, but does not fire. Possible smell on unburnt fuel. The tach need flutters a bit while starter is engaged. After leaving van to cool down for a few minutes or longer, it starts and runs fine.

My first suspicion is that there is dirt on the contacts in the big connector between the fuel injector cable and the fuel electronic control unit, and that I should clean the contacts on both sides of the connector with CRC-626. This was a problem many years ago, but only showed up in cool damp weather.

My second suspicion is that their is a problem with the ignition control unit. I replaced that unit in 2003 when I put in a Boston Bob long block. The fuel injection cable and the fuel ECU are the same ones that were on the van when I bought it in 1997.

I would appreciate the wisdom of the list in solving this problem.

John


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.