Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2015, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 1 Aug 2015 23:52:47 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: What is it?
Comments: To: "SDF ( aka ,jim lahey' - Scott )" <scottdaniel@turbovans.com>
In-Reply-To:  <55BDB274.8010008@turbovans.com>
Content-Type: text/plain; charset=UTF-8

Thanks for identifying that partial yellow ring Scott. Interesting details! I didn't really think it "played into" the cause of the OP's fuel leak but thought I'd ask of it.

When checking injector spray pattern on my 2.1 WBX, sometime after I replaced ALL the fuel hoses in engine bay, simply lifting the set of 2 injectors up and away from the driver side engine head caused a ***tiny*** bit of fuel to seep out between the fuel rail and hose. This was obviously due to a slightly loose clamp. (much like a radiator hose clamp replacement, I should have re-checked all fuel hose clamps some miles after doing the fuel hose replacement job). Tightening that fuel hose clamp fixed the issue. I re-checked all relevant fuel hose clamps.

@ the OP. I may be mistaken, but I don't see that fuel pressure regulator bolted down. Not that it matters per se, (as a fuel hose replacement job may be in your near future), but I'd guess that simply moving that part, and hoses attached to it, could have disrupted those old hoses and clamps enough to cause a fuel leak ??

Neil.

On Sat, Aug 1, 2015 at 11:02 PM, SDF ( aka ;jim lahey' - Scott ) < scottdaniel@turbovans.com> wrote:

> Starting back when cars started having pretty complex emissions systems > ...and often Lots of vacuum hoses and devices ( you should see a pre-fuel > injection Calfiornia Rabbit sometime ..like 20+ vacuum hoses ) .. > > it became a Federal Requirement that all US cars have a Vacuum Diagram > ...under the hood, even on the underside of the hood sometimes .. > and little colored plastic rings like the yellow one on the Fuel Press. > regulator in the pic . > > >

-- Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.