Seeing that the ground wire "looks connected" isn't good enough. The clicking indicates a good relay if anything. If you attach a new wire from the ground stud of the fan motor to clean bare metal of the body you can test whether the existing ground is doing its job. It probably isn't. I like to permanently add a new ground wire from the motor and screwed to the body instead of relying on the weak spade connection of the stock ground wire. Mark
Michael wrote: > So far I've replaced the resistor, followed the ground to the tree (looks connected) and get a clicking noise from the relay when jumping the plug connector. > > The AC on this van is not connected because it is a Subaru conversion. > > Do you think the clicking is a bad relay up top behind the fuse box? > > I do have the Bentley and have taken a look at the wiring diagrams, but that's about it. > > Mike > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.