Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2015, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 25 Aug 2015 19:59:52 -0500
Reply-To:     jpalmer@MYMTS.NET
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeff Palmer <jpalmer@MYMTS.NET>
Subject:      Re: Supporting the pop top to remove the frame
Comments: To: David Beierl <dbeierl@attglobal.net>
Comments: cc: Jim Felder <jim.felder@GMAIL.COM>
In-Reply-To:  <201508251930.t7PJUPTX032360@mail113c45.carrierzone.com>
Content-Type: text/plain; charset="us-ascii"

Define "unfolded." :)

Extended? That is with top raised? Collapsed? With top down? Unsecured? Detached at the roof? Insecure? Generally uncomfortable with its place in the camping world?

And how did you lube it after install? Grease or graphite or ...

Thanks as always! Jeff

Sent from my iPhone

> On Aug 25, 2015, at 2:30 PM, David Beierl <dbeierl@attglobal.net> wrote: > > At 11:59 AM 8/25/2015, Jim Felder wrote: >> Don't do this with the assembly in the car. Take it out first with the top >> propped up. After you remove the crossbar, you have removed the axle that

>> keeps the spring from separating the upper and lower halves by whatever the >> remaining distance of the spring is, three or four inches. You don't want

>> to deal with getting that back together in the car. In fact, you don't want >> to deal with it at all by yourself, but in no case in the car. > > Jim, with the brace unfolded there's no spring pressure. I did the complete job from diagnosis through making ends on the lathe and installing them by myself in a couple of hours before I left to catch a ferry 150 miles away that I'd paid for already. That included taking those pictures and figuring it all out on the fly. I supported each side of the roof separately while I worked on that end. Supporting the middle could well be better, I just didn't think of it under the gun. > > I certainly cut the tube before removing the discarded end piece, Rotating the stub piece while trying to remove it will give bearing support in any needed direction to nudge the bearing edge into alignment. <-- Jeff Palmer > > Yours, > David


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.