Start with the wire to the sensor. If an original set up the temp sensor is a single wire connection at the front of the thermostat housing. It is common for the wire to break at the crimped connector. Dennis
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Kk Al Sent: Saturday, September 5, 2015 5:09 PM To: vanagon@GERRY.VANAGON.COM Subject: 87 Syncro no temp gauge We noticed today that the temp needle didn't budge at all. The radiator is still getting warm, the heaters still work and the coolant level is fine. The red warning light in the temp gauge flashes a few times when we turn on the ignition, then remains off. How do we track this problem down? Thank you in advance |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.