Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2015, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 12 Sep 2015 09:15:33 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Rough Idle troubleshooting need
Comments: To: Steven Mills <StevenM@RED-ROCK.COM>
In-Reply-To:  <3714C9161F26E247AC671BB0D52EF09639CF3AF8@okcmail03.RED-ROCK.com>
Content-Type: text/plain; charset="us-ascii"

Next time it begins running rough try cycling the ignition off and back on. Yes you can carefully do this while moving. If the conditions clears up for a short while then you need to look at a problem with the O2 sensor system. Wiring problems can be elusive. The wire can and crimp can look good with the wire inside the insulation so bad it has high resistance. The chassis reference for the O2 sensor is extremely critical. The ground for the distributor hall sensor is shared with the O2 sensor. Many 87s have that connected at the base of the plastic oil breather tower. Move it if needed.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Steven Mills Sent: Friday, September 11, 2015 11:37 AM To: vanagon@GERRY.VANAGON.COM Subject: Rough Idle troubleshooting need

I will try to keep this as brief as possible. 87 Vanagon, stock 2.1. intermittent rough run and loss of pwr. So far, have tested with good parts ECM, AFM, Dist, plugs, plug wires, alternator, coil, fuel pressure/flow rate, idle stabilizer, cold temp sensor, good fuel, fuel filter, fuel pump, fuel injectors, O2 sensor, ohm'ed wires to and from all components. Have done wiggle test on as many wires as we can get to or think of. Checked for vacuum leaks. When running good, very smooth idle, warm-up cycle, acceleration, etc . Never had one run better in my 25 yrs of owning one. Just had about 6 days of 300 plus miles of driving without a hitch. When rough, sometimes can be smooth for first 5-10 secs, then problems surface. Most of time, when rough, rough from very beginning. Have worked alongside a mechanic who has worked vanagons since the 80's, but we are both stumped. Could use any and all ideas/suggestions. Or someone to suggest in this region of the country. Steven Mills, Oklahoma


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.