Date:         Fri, 25 Sep 2015 20:41:24 -0700
Reply-To:     Don Hanson <dhanson928@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson928@GMAIL.COM>
Subject:      Re: Oil Temperature??
In-Reply-To:  <560606B2.4020006@turbovans.com>
Content-Type: text/plain; charset=UTF-8

I saw a 15-20 f drop in temperature with my ABA inline VW....when I
installed the vanagon standard type oil filter/heat exchanger after I
swapped blocks from a 1.8 liter Rabbit gas motor, which ran with no cooler
from the factory...So the standard VW cooler does do some significant
cooling in my experience...

   If I owned a WBX motor I certainly would, given the wide spread issues
with flicker oil lights after a fast run, and other indications that low OP
and high temps exist in the motors, I certainly would have some oil cooling
system to keep the oil under about 240f max...

On Fri, Sep 25, 2015 at 7:45 PM, SDF ( aka ;jim lahey' - Scott ) <
scottdaniel@turbovans.com> wrote:

> works both ways ..
> when cold, coolant warms up faster than the oil ...
> and thus helps warm the oil .
>
> when hot ...when oil temp is high, cooling system helps keep the oil
> temp from getting too high.
> there are limits to what the stock oil cooler can do.
>
> An oil cooler/heat exchanger like this is generally always a low cost
> slight improvement ..
> worth 10 %  or so.
> there are 'taller ones' ...from late VW's that will fit ....well ..not
> if the oil filter then runs into  the exhaust pipe, like on a waterboxer.
> But tdi people install later, taller versions over the normal size though.
> scott
>
>
> On 9/25/2015 4:15 PM, Dan N wrote:
>
>> thanks...
>>
>> so the heat from the oil was transferred to the coolant circuit which keep
>> the oil temp down...?
>>
>> did you notice a raise in coolant temp?
>>
>>