Date:         Sun, 27 Sep 2015 07:51:15 -0700
Reply-To:     Joe Novak <joe.novak.6@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Joe Novak <joe.novak.6@GMAIL.COM>
Subject:      Door Panel Clip Installation
Content-Type: text/plain; charset=UTF-8

Maybe i haven't had enough coffee this morning... anyway, i could use some
advice.

I'm harvesting the door panel clips off of my warped front door panels on
my 86 to place on
newly acquired, pre-covered panels.

Is there a trick to placing the clips into the pre-drilled holes so i don't
snap the top of the head?
I assumed that I could go in from the back side of the panel, but its
proving to be problematic for me this am...

Thanks!
jvk

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.