Frank, pages 97.50/51 show an 83 version that uses a control box. It might be close enough to the 84 to help. Mark
Frank Condelli wrote: > Folks, I need some help with the wiring for an auxiliary gas heater on a 1984 Westy. The wires on the back of the control box on the dash are off and I cannot find the plan in the Bentley that shows what wires go to that box. The multi terminal plug is obvious so that’s OK but there are two spade terminals to the side of that plug that I do not know what goes on them. There are two 12v un-switched power wires and one ground wire loose under the dash that are not connected to anything an they all could reach that box so I’m not sure if those spade terminals are a 12v positive and a ground or what. Any help would be appreciated. > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.