Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2015, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 16 Nov 2015 12:05:23 -0700
Reply-To:     OlRivrRat <OlRivrRat@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         OlRivrRat <OlRivrRat@COMCAST.NET>
Subject:      Re: Oil Pressure Switch Removal
In-Reply-To:  <CAB2Rwfi9StKsDp3ETPs2bpdPXNo3Oq9uXrS3bds+BV00VJr5vw@mail.gmail.com>
Content-Type: text/plain; charset=windows-1252

Get this set ~ I have had 1 for several years & use it lots ~

http://www.sears.com/craftsman-3-pc-socket-cap-set/p-00943303000P

On 16 Nov , 2015, at 11:14 AM, Neil N wrote:

> Would a piece of steel square bar fit the 3/8" drive socket? > Put an open end wrench on that? > I've seen square tube at hardware stores. > Would a suitable length of that be strong enough? > > > On 11/16/15, Frank Condelli <RAlanen@aol.com> wrote: > >> As Denis says, however I have never needed to remove the pulley. I >> use 1/2” drive socket then use a 3/8 reducer inserted 1/2 way into the 24mm >> socket then use a 1/2” ~ 13mm open end wrench on the reducer to turn the >> socket. > > > -- > Neil n > > Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca> > > 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy> > > 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/> > > Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.