This has never happened to me. On Sun, Dec 13, 2015 at 3:28 PM, Robert Clemmer <n51219@comcast.net> wrote: > Bentley says to back out the adjusting screw until it is flush with the > rocker arm, then turn engine to TDC on #1 and start from there. > > > > If I back out the screws that far, don't I run the risk of the pushrods > dropping out of the lifters? > > > > Bob C > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.