Date:         Sun, 31 Jan 2016 00:05:20 -0700
Reply-To:     OlRivrRat <OlRivrRat@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         OlRivrRat <OlRivrRat@COMCAST.NET>
Subject:      Re: Looking for 4mm by 1.0 threads per mm tap
Comments: To: Karl Wolz <wolzphoto@Q.COM>
In-Reply-To:  <670BB5A9-6183-4A1B-A751-5CE6626FD5D9@q.com>
Content-Type: text/plain; charset=us-ascii

        If You have an Ace Hardware near by have a look there ~

On 30 Jan , 2016, at 10:49 PM, Karl Wolz wrote:

> These are the screws that hold the wiper assembly to the dash valance(?). 
> 
> Karl Wolz
> Sent from my electronic umbilicus
> 
>> On Jan 30, 2016, at 10:41 PM, Dennis Haynes <d23haynes57@hotmail.com> wrote:
>> 
>> McMaster Carr has most anything. For M4 I am only familiar with .7 and .75
>> pitch. M6 is available in 1.0, .75, and .5.
>> 
>> Dennis
>> 
>> 
>> 
>> 
>> -----Original Message-----
>> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
>> Karl Wolz
>> Sent: Saturday, January 30, 2016 11:51 PM
>> To: vanagon@GERRY.VANAGON.COM
>> Subject: Looking for 4mm by 1.0 threads per mm tap
>> 
>> All I've found are finer threads. This is for the windshield wiper assembly.
>> Any ideas?  Tried HF and Sears and Home Depot. They all have finer thread
>> taps. 
>> 
>> Karl Wolz
>> Sent from my electronic umbilicus