Finally got back to my '83 project van. I'd replaced the tranny a few months ago but for unrelated reasons had to leave the project for a few months. Finally, took it for a test drive today. Initially had problems finding gears, but much of that was sorted out by following the Bentley's shift linkage adjustment procedure. However, the biggest and unresolved problem is that it simply will not shift into second or fourth gear. The shift lever simply feels blocked from accessing second or fourth and if I apply pressure I get the unhappy sound of gears grinding. I shortened up the shift rod by moving the front shift rod further into the splines in the rear shift rod, but that didn't seem to help. Is this symptomatic of a bad pilot bearing (which I didn't replace but probably should have) or what? Thanks, Rick |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.