Could someone make a mold? If so, it could be done with lead, the same way you make cast bullets. GregM -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Karl Wolz Sent: Tuesday, April 26, 2016 9:55 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Vent wing seals? Anybody? Ken, the latch that keeps the vent closed is held by a screw that fastens through a lead piece. It is perhaps a half inch wide and is conical. I believe it is lead to absorb impacts and keep the vent from shattering. Karl Wolz Sent from my electronic umbilicus > On Apr 26, 2016, at 4:10 PM, kenneth wilford (Van-Again) <kenwilfy@COMCAST.NET> wrote: > > scratching |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.