Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2016, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 6 May 2016 18:47:10 -0700
Reply-To:     Alistair Bel <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bel <albell@SHAW.CA>
Subject:      Re: Rear Brakes: E-brake lever lube,
              E-brake spring function (purpose)
Comments: To: Dennis Haynes <d23haynes57@HOTMAIL.COM>
In-Reply-To:  <BAY180-W937D0B8CFF6AF4A4BC86C8A07D0@phx.gbl>
Content-Type: text/plain; charset=us-ascii

My last purchase of rear shoes fit the radius very closely. I wish I could remember the brand, I can't be sure but it might have been local Napa. Or I might have got them from local vw mechanic who gets from wholesaler altrom.

Alistair

> On May 6, 2016, at 4:33 PM, Dennis Haynes <d23haynes57@HOTMAIL.COM> wrote:

> > Almost all of the aftermarket shoes need to be shimmed out at the bottom to work properly. I have has some that needed 4mm on each. I think the problem is that they are using the same pattern as the earlier busses that had manual star wheels. The GoWesty shoes have been very consistent for fit and reasonably priced. > > Dennis > > >> Date: Fri, 6 May 2016 13:10:12 -0700 >> From: musomuso@GMAIL.COM >> Subject: Re: Rear Brakes: E-brake lever lube, E-brake spring function (purpose) >> To: vanagon@GERRY.VANAGON.COM >> >> Ah, ok. Shoulda known better re: shims. ;) >> I see the shoe contact points on backing plate. Good tips. >> >> I've often wondered that if a backing plate became thin enough due to corrosion, >> would it flex under hard braking conditions. >> >> So many details! >> >> Neil. >> >> >>> On 5/6/16, Dennis Haynes <d23haynes57@hotmail.com> wrote: >>> There are no shims on those lower anchors. With the GoWesty shoes and new >>> drums there is no room for shims. The GoWesty HD drums are even a tighter >>> tolerance. The silver you see there is nickel based anti-seize. Not that I >>> also used brake grease on the pads where the shoes rest on the backing plate >>> and where the shoes rest on the cylinders and lower mounts. >>> >>> The creeper is known as "The Bone". it has large wheels that easily roll

>>> over obstructions like tools. >>> >>> Dennis >>> >>> >>>> Date: Thu, 5 May 2016 22:34:18 -0700 >>>> Subject: Re: Rear Brakes: E-brake lever lube, E-brake spring function >>>> (purpose) >>>> From: musomuso@gmail.com >>>> To: d23haynes57@hotmail.com >>>> CC: vanagon@gerry.vanagon.com >> >>>> Wow. Just, wow; those backing plates have seen better days! >> >> >> -- >> Neil n >> >> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca> >> >> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy> >> >> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/> >> >> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.