I'm going to replace the propane lines on our van when replacing our propane tank. I'm familiar with the basics of bending and flaring the tubing. Can I easily do this without removing any of the interior of the kitchen? (That was all taken out and serviced in the not-too-distant past.)
My plan was: 1) cut the previous lines by the tee fitting outside the van, and remove them from the interior. 2) make new lines using the old ones as guides. Leave an extra length at the bottom of each. 3) Refit them through the interior. 4) Add the outside bend to each line and attach to the tee. Will this work without removing any of the kitchen? Thanks! Wes |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.