Date:         Sat, 28 May 2016 16:32:13 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: {front} wheel bearings on an '88 Westy
Comments: To: Neil N <musomuso@GMAIL.COM>
In-Reply-To:  <CAB2RwfgzhgKWE7UtKOMkTEjCn3D3G3GLX8NvfM-EYO8swdGp1Q@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"

Yes.
That trick can take out the play and prevent the inner race from spinning on the spindle. A professional method would be to knurl the shaft. 

Dennis. 

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Neil N
Sent: Saturday, May 28, 2016 2:22 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: {front} wheel bearings on an '88 Westy

I think you mentioned this before Dennis, but would making 3 equal spaced punch marks at spindle where bearing inner race seats help?
Or have I misunderstood what is meant here?

Neil.

On 5/27/16, Dennis Haynes <d23haynes57@hotmail.com> wrote:


> More concerning is that most of these spindles now have enough wear on 

> them that the outer bearing is not a tight fit.


--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>