Date: Wed, 22 Jun 2016 19:15:24 +0000
Reply-To: den jolliffe <sondancer77@YAHOO.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: den jolliffe <sondancer77@YAHOO.COM>
Subject: Re: Problem with push rod tube seals?
In-Reply-To: <29AC5B5D6F4E40D299FE0CA0B5F47FD6@ZoltanHP>
Content-Type: text/plain; charset=UTF-8
Not WBX related, but Victor Reinz related on a recent T-4 back from the dead 1.8 FI build....
Valve cover gaskets 71-21728-00 have become thinner and narrower to a point where I'm going to have to glue them in...I've always been good with dry on dry (DAS)...but comebacks really hurt when the product changes...
Den.
On Wednesday, June 22, 2016 3:00 PM, thewestyman <zolo@FOXINTERNET.NET> wrote:
Ken,
That Reinz gue is not that effective. I use Right Stuff without any come
backs. But I also pull on the ends of those tubes before I install. And
clean everything with Acetone.
Right Stuff is what I use for the head gasket installation too with copper
liquid for the head-cylinder meetings. All surfaces, including the inside
and outside of the rubber gasket sanded and cleaned with Acetone.
Zoltan
-----Original Message-----
From: kenneth wilford (Van-Again)
Sent: Wednesday, June 22, 2016 6:02 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Problem with push rod tube seals?
So I have been using the Victor Reinz and or the Erling complete engine set
for years and years to on rebuild engines and cylinder head jobs. We have
done so many over the years with no real issues. However the last two
engines we rebuilt started having problems with oil leaks from the push rod
tube area not long after we rebuilt the engine (probably 2000 miles
range). I just had one of the customers in here this morning and it seems
like an issue with the push rod tube seal itself. The small end ones
seemed to be expanding and trying to squish out around where they seal to
the interior of the engine under the valve cover. One was so bad that it
cut in half and the other two on the opposite side of the engine were just
starting to emerge and do the same kind of thing. Not all of the seals
were doing this, the large end seals which are made of the same material
were fine and most of the other small seals seemed to be fine. Anyone else
have a similar issue lately? I am just wondering if it is an isolated
problem or something I should call my supplier about? I think the kits we
have used lately have all been the Victor Reinz ones if that helps out.
--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com