Date: Wed, 22 Jun 2016 14:04:00 -0400
Reply-To: "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Subject: Re: Problem with push rod tube seals?
In-Reply-To: <028b01d1cca7$2cccd080$86667180$@gmail.com>
Content-Type: text/plain; charset=UTF-8
That sounds like a reasonable explanation. I can see how they would get
work hardened when they are restretched and we did reuse
good used ones on this rebuild because it was a few years ago and there
were no new tubes available at the time. Now I can get them again fairly
cheaply so I would use new no matter what. I did just this on a cylinder
head replacement job we just did. I hate when reusing old parts comes back
to bite you in the butt. Usually when you are doing it to save the
customer some money too.
Ken
On Wed, Jun 22, 2016 at 12:57 PM, Stuart MacMillan <stuartmacm@gmail.com>
wrote:
> Wow, that's an odd one. I have to contribute my 2 cents worth on this
> just for fun. I'll bet the old pushrod tubes are the problem, not the
> seals. They may get less malleable as they age, and after stretching them
> for reuse they may not have the flexibility they once had, and that leads
> to too much pressure on the seals.
>
> I assume you'll replace these tubes with spring loaded ones, and I doubt
> you will have any problems with them. You may want to replace the pushrod
> tubes with new ones on all your rebuilds now.
>
> Stuart
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
> Of kenneth wilford (Van-Again)
> Sent: Wednesday, June 22, 2016 9:03 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Problem with push rod tube seals?
>
> So I have been using the Victor Reinz and or the Erling complete engine set
> for years and years to on rebuild engines and cylinder head jobs. We have
> done so many over the years with no real issues. However the last two
> engines we rebuilt started having problems with oil leaks from the push rod
> tube area not long after we rebuilt the engine (probably 2000 miles
> range). I just had one of the customers in here this morning and it seems
> like an issue with the push rod tube seal itself. The small end ones
> seemed to be expanding and trying to squish out around where they seal to
> the interior of the engine under the valve cover. One was so bad that it
> cut in half and the other two on the opposite side of the engine were just
> starting to emerge and do the same kind of thing. Not all of the seals
> were doing this, the large end seals which are made of the same material
> were fine and most of the other small seals seemed to be fine. Anyone else
> have a similar issue lately? I am just wondering if it is an isolated
> problem or something I should call my supplier about? I think the kits we
> have used lately have all been the Victor Reinz ones if that helps out.
>
> --
> Thanks,
> Ken Wilford
> John 3:16
> www.vanagain.com
>
--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com
|