On Tue, 28 Jun 2016 21:15:48 -0700, Alistair Bell <albell@SHAW.CA> wrote: >I considered the under the van install. What's the model number for the unit designed to do that? 2211? > >I thought about making a sealed box for the the HS2000 that I have. But what put me off was drilling the holes for the heating air inlet and outlet. It was a hole size too far :-) > >Then again when I think about it now I wonder if it might have been a better route. > Only the 2211 will fit properly underneath, as the exhaust and inlet pipes for the burner exit on a side vs the bottom as on the 2000. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.