Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2016, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 29 Jun 2016 17:59:00 -0400
Reply-To:     Karl Mullendore <tdiguru@WESTYVENTURES.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Mullendore <tdiguru@WESTYVENTURES.COM>
Subject:      Re: Propex heater install part two

On Tue, 28 Jun 2016 22:15:01 -0700, Alistair Bell <albell@SHAW.CA> wrote:

>Right Karl, the bottom pipes on the 2000 would make an under the floor mount pretty deep, heater profile hang low. But if the 2000 was mounted in its side the pipes would come out horizontal, not so bad.

4" + curved pipes or 7" on the side, both plus protective box = 8"? That's why the 2211 is the only real option for underneath, at 5".

Karl


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.