Date:         Sun, 3 Jul 2016 17:26:07 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: Speedometer is off
Comments: To: Stuart MacMillan <stuartmacm@gmail.com>
In-Reply-To:  <007d01d1d586$f3874ec0$da95ec40$@gmail.com>
Content-Type: text/plain; charset=UTF-8

Thanks Stuart.

Ya, likely my ham handed-ness cause this but for sure the speedometer needle
was very tight to spindle. If I recall, there was a small gap between
face of speedometer
and end of metal part of needle that slips over shaft. Thought maybe a
tool could be put at that
point to prise the needle up and off. Good tip on pre load added measurement.

> VDO should really be ashamed of themselves for how lazy they were in making
> these speedos.

At the original poster:
if you need to take apart your speedometer,
consider adding a bracket on speedometer to help hold
the odometer shaft in place. Image of what I mean:

http://tinyurl.com/hdqsnow

Neil.

On 7/3/16, Stuart MacMillan <stuartmacm@gmail.com> wrote:

> Spoons need to be as close to the center of the disk the needle is mounted
> to, or you risk breaking that disk.  My needle was incredibly tight. I've
> had good speed correction moving the needle about 1/4 to 1/2 inch farther
> than that spot you reference.
>
> VDO should really be ashamed of themselves for how lazy they were in making
> these speedos.


--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>