Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2016, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 5 Jul 2016 12:39:59 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Propane Tank, Fittings
Comments: To: Neil2 <vidublu@GMAIL.COM>
In-Reply-To:  <CAGzDsVYFjmMgQTp09ONYo5qp+xZGMR+tJ2DRovQWZZKn8n4n0Q@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"

I'm curious as to what is really being done as part of that "refurbishment". If it is clean, sand, prime and paint that is not a refurbishment. As an ASME stamped pressure vessel all repairs and tested/Inspected must be dome or at least someone with the certifications to so. Often this is known as getting as "R" stamp. This is commonly done with larger tanks and boilers, steam coils etc.

These small tanks are really inexpensive and replacement is in order. As some of you remember I had mine fail about 3 years ago at a propane filling station. As the fire department arrived with 5 trucks things got scary.

After the event was over and the tank empty I was asked a whole bunch of question, many which needed follow after I returned home. Luckily my tank still had the ASME tag attached and the fire chief knew to look for it. I also had to get documentation that this tank was installed by the OEM.

The propane system as small as it is it not something to be taken lightly or have short cuts. The installation is covered under a number of codes and in our Westy has to follow requirements for dwellings and recreational vehicles.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Neil2 Sent: Tuesday, July 5, 2016 12:09 PM To: vanagon@GERRY.VANAGON.COM Subject: Propane Tank, Fittings

Can anyone send/post a source for the various fittings for the OEM LPG tank? I've replaced the regulator and T but would prefer to replace the overflow valve, shutoff and any others while after mine is refurbed. Please/thanks!

-- Neil2 '82 Diesel Westfalia (Ducky) '86 Vanagon (SaVannah) '08 170" 2500 Mega Roof Sprinter (Moby) '90 Westfalia Subagon Fulltiming since August 2008 Nunquam Pendite Divendium


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.