Many thanks to everyone for their suggestions on how to loosen the fitting on the condenser. I wound up cutting it off with a cutoff wheel on a Dremel tool. Time will tell if I fubar'd it.
Now I have another issue I hope folks can help me with.
Car is a 91 2.1 wbx automatic. I replaced the A/C compressor, receiver/dryer, and the hoses to the condenser. I have it all buttoned up and ready to go to the shop to charge the system.
I have a broken brown wire with a blue tracer coming out the same harness as the three wires to the Hall Sensor on the distributor. I cannot find for the life of me where this wire goes and I hoping someone can point me in the right direction.
Thanks, Bob C |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.