Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2016, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 20 Jul 2016 19:08:52 -0700
Reply-To:     Scott - IMAP <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott - IMAP <scottdaniel@TURBOVANS.COM>
Subject:      Re: Expansion tanks
Comments: To: Stan Shapiro <mail@STANSHAPIRO.COM>
In-Reply-To:  <012501d1e2ea$d8878600$89969200$@stanshapiro.com>
Content-Type: text/plain; charset=utf-8; format=flowed

whenever possible avoid ALL Meyle products. Definitely on the weak end of the scale, IMO.

re your comment on the blue caps. Supposedly it's a 'regular' pressure cap with coolant recovery valve.

However.. they don't always release pressure when they should ..seen that lots ( if they did, expansion tanks would not puff up sometimes ) 'Usually' the 'suck-back- feature works .

yes, excess pressure should be vented to the overflow tank, but they don't always work that way like they should, in my experience.

Scott

On 7/20/2016 5:57 PM, Stan Shapiro wrote: > The brand tank that I used was MEYLE. Haven’t checked for combustion gases yet. I have replaced these tanks over a period of about 20,000 miles. Runs fine. No symptoms of bad head gasket. I guess I don’t fully understand the blue cap on the expansion tank—I would think that any excess in pressure in the expansion tank (gas or fluid) would be vented into the overflow tank. > > > > Thanks > > stan > > > > From: kenwilfy@gmail.com [mailto:kenwilfy@gmail.com] On Behalf Of kenneth wilford (Van-Again) > Sent: Wednesday, July 20, 2016 2:35 PM > To: Stan Shapiro > Cc: Vanagon List > Subject: Re: Expansion tanks > > > > Have you checked for combustion gasses getting into the coolant? What brand of tanks are you getting? > > > > Ken > > > > On Wed, Jul 20, 2016 at 5:27 PM, Stan Shapiro <mail@stanshapiro.com> wrote: > > I am on my 4th NEW coolant expansion tank in about a year. They leak at the > seam. Any suggestions for a replacement? I have seen the metal tanks, > that I am sure are bullet proof, but I do like the ability to check the > coolant level in the expansion tank just by looking through the plastic. > > Suggestions? > > > > stan > > > > > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.