Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2016, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 21 Jul 2016 19:40:26 -0700
Reply-To:     Steven P Smith <kewsps@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steven P Smith <kewsps@HOTMAIL.COM>
Subject:      Re: 1991 Carat - the drama continues
In-Reply-To:  <57916AE5.8040504@cox.net>
Content-Type: text/plain; charset="Windows-1252"

Just fixed a very long term intermittent problem on my '84 Westy. Typical intermittent loss of power and rough idle, then back to normal. After changing everything on the likely list, I discovered that #1 cyl wasn't contributing its fare share of the work which led me to remove the fuel injector leads and put them on the other injector or something like that. I eventually concluded that there was something wrong with the connector so I replaced it and the problem is gone, hopefully, finally, for a long time. That was a real pain that many people spent many hours trying to fix over the years...

> Date: Thu, 21 Jul 2016 17:37:57 -0700 > From: madvws@COX.NET > Subject: Re: 1991 Carat - the drama continues > To: vanagon@GERRY.VANAGON.COM > > This is an issue with electrical problems in general. People replace a > part and then say that "fixed it" so the old part must have been bad. In > older vehicles in particular this is often not the case. Starters and > alternators are examples where this happens in Vanagons, IMHO. The real > fix may have been simply removing and reinstalling the connections, and > possibly cleaning the connections "as long as I am in there". > > Mark > > > Dennis Haynes wrote: > > It would be very rare for an oil pressure switch to completely fail out of the box. I've seen them be way out of tolerance not yet one that didn’t work at all. It is possible that you really have a wiring issue and that moving stuff made the system work for now. This is usually the case when someone thinks they fixed an operating problem by replacing the temp 2 sensor. Simply wiping the contacts or moving the wires where crimped in those connector terminals did the fix. > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.