Date: Wed, 24 Aug 2016 19:06:48 +0000
Reply-To: Jared Planter <jaredplanter@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jared Planter <jaredplanter@GMAIL.COM>
Subject: Re: Van wants to stall at start..but only sometimes
In-Reply-To: <013a01d1fe3a$856593c0$9030bb40$@gmail.com>
Content-Type: text/plain; charset=UTF-8
Thanks for the information. The starter battery is new so I'll have the
alternator tested and see if that changes anything.
On Wed, Aug 24, 2016 at 12:05 Stuart MacMillan <stuartmacm@gmail.com> wrote:
> It's not the noisy flat lifter, that's a feature of the WBX engine, though
> it can cause a miss until it pumps up. Could be a weak battery combined
> with a weak alternator, it was in my case anyway. Have them both tested.
>
> Stuart
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
> Of Jared Planter
> Sent: Tuesday, August 23, 2016 10:53 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Van wants to stall at start..but only sometimes
>
> Hi all,
>
> My wife and I purchased an 87 automatic 2WD westy back in March of this
> year and have been having a great time with her. We've done a fair amount
> of upgrades in areas we feel are important, especially since we will be
> living in her full-time come early 2017.
>
> She runs rock solid and has given us very few issues. Except for this one
> strange issue that has occurred 2 times now. Upon the first start of the
> day we'll turn over the engine and it'll appear to be normal at first until
> suddenly the RPMs drop to about 600-800 and it sounds like she's about to
> stall. You can hear what sounds like the bearings on the pulleys rattling
> and a squeaking noise because of the low RPMs. I have found that getting in
> and holding the gas pedal at 1K RPMs for a couple of minutes resolves the
> issue. Stopping and starting again results in the same symptoms. Again,
> this has only happened 2 times - in this exact order.
>
> However, on one separate occasion she was running fine after being started
> and I switched into drive before she was warm and then the conditions above
> started played out. At that point I switched into park and held the RPMs at
> 1K otherwise she would have stalled.
>
> We have a known issue with the lifter on cylinder 4, apparently it's a
> common issue with Vanagons where the oil pressure drops and needs to be
> built back up by driving and then the somewhat knocking sound goes away. It
> might be related to this but I am unsure.
>
> Any thoughts or anyone with a similar experience?
>
> Thank you!
>
> Jared
>
>
|