Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2016, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 Sep 2016 09:39:46 -0600
Reply-To:     Patrick Seurynck <climb12@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Patrick Seurynck <climb12@GMAIL.COM>
Subject:      Sliding door
Content-Type: text/plain; charset=UTF-8

I follow these posts daily and I have been inspired numerous times to do
projects on my van from them.
Thanks!
I need help with a part.
It is the mounting plate that holds the rear pull handle on the Inside of
the sliding door.
The plate is roughly 1x 2 inches that has a square stud about an inch
long mounted in the center.
The plate is mounted behind the finish panel on the door and the stud
protrudes through the panel and the handle is mounted to that.
'84 West, 2wd, manual, 1.9l
I tried attaching a photo but it was rejected.
Thank You!




--
Sent from Gmail Mobile
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.