Date:         Sat, 19 Nov 2016 17:19:53 -0800
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: 2.1 WBX Warm Start Troubles
Comments: To: David Beierl <dbeierl@attglobal.net>
In-Reply-To:  <201611200102.uAK12OpD030642@mail162c45.carrierzone.com>
Content-Type: text/plain; charset=UTF-8

Along with Davids comments I'd suggest visually inspecting the inner
lead of the O2 green coax near the connector on body portion of
harness. I see the warm start issue was present before the O2 sensor
was swapped out, but a break at the inner wire casing can allow
strands of the coax shield to touch the centre lead. This fault could
be intermittent. A little WD40 makes it easy to slide back the rubber
boot at the connector.

Neil.


On 11/19/16, David Beierl <dbeierl@attglobal.net> wrote:



>
> Oxy sensor shorted to ground is the other huge villain (along with
> Temp-II) giving super-rich operation, but even on a warm start that
> shouldn't have any effect at the moment of starting; it kicks in 30
> seconds or a minute later, just long enough to get from the motel
> parking lot to the road before it suddenly hates idling.  Still, I
> suggest with any running problem at all to disconnect the sensor,
> check that the line isn't grounded (should see ~.45 volts on the ECU
> side with a digital voltmeter), and leave it disconnected until the
> engine is running properly.  The only thing that needs it is the
> catalytic converter, and it can really mess you up.
>
> Yrs,
> d
>


--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>