Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2017, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 18 Feb 2017 16:17:34 -0800
Reply-To:     Don Hanson <dhanson928@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson928@GMAIL.COM>
Subject:      Re: Blinking coolant light woes
Comments: To: Steven Shelton <shelton4@gmail.com>
In-Reply-To:  <CAHTkEu+Ega=UecS5yYSoYuc+UNjn0chBkPFG3v7amkU+QG2ccg@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8

I gave up on mine. Black tape stopped the blinking, oil temp/coolant temperature gauges work for my internal engine temperature, alternator light for coolant pump function... I have an inline, so it's not gonna die easily..

On Feb 18, 2017 3:40 PM, "Steven Shelton" <shelton4@gmail.com> wrote:

Sorry, I didn't read the part where you already tried that.

On Sat, Feb 18, 2017 at 6:38 PM, Steven Shelton <shelton4@gmail.com> wrote:

> Mine did the same thing and it was the temperature gauge itself. dbeierl > has an excellent explanation and test procedure here: > > http://www.thesamba.com/vw/forum/viewtopic.php?t=353678& > postdays=0&postorder=asc&highlight=img+http+images. > thesamba.com+vw+gallery+pix+1376779.jpg+img&start=0 > > > On Sat, Feb 18, 2017 at 6:08 PM, Jim Felder <jim.felder@gmail.com> wrote: > >> I've recently had my share of problems with a blinking coolant light. I >> have done everything I could think of to do: >> >> 1. New pressure cap (but it's Meyle brand, so a better one is next) >> 2. Replaced the gauge with a re-capacitored one David B did for me years >> ago >> 3. Cleaned all the terminals and finessed the connectors on the foil. >> 4. Made sure grounds were in fact grounds. >> 5. Made sure the coolant was as full as possible, and was mixed properly. >> >> It would not stop blinking at some point on a trip as short as three of >> four miles. I ended up jumping the connector so that the light will at >> least stay off, and it does. I have all new hoses and tank, and no other >> leaks so I am not worried about the coolant going low on me. >> >> Any ideas as to where to look next? Before I jumped the connector, it >> would >> usually--but not always--start off without blinking, but after a few miles >> it would begin. I have pulled over to check the coolant a lot and never >> found it low. >> >> Jim >> > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.