Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2017, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 27 Mar 2017 16:18:18 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Both temp light and gauge not working
Comments: To: B Feddish <uprightbassghost@hotmail.com>
In-Reply-To:  <BN3PR0601MB1266E75FAD3AFC82C387A80FCE330@BN3PR0601MB1266.namprd06.prod.outlook.com>
Content-Type: text/plain; charset=UTF-8

Ok.  Gauge is good, panel connector is good.  Most likely problem is bad
contact at the gauge sender back at the thermostat housing, though it's
possible the sender itself is open.


Yrs,
d


On Mon, Mar 27, 2017 at 4:02 PM, B Feddish <uprightbassghost@hotmail.com>
wrote:


>
> I took the plug out and the gauge goes all the way left and the light
> blinks.  What should I check from here?
>
>
>
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.