Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2017, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 23 Mar 2017 05:19:45 -0500
Reply-To:     John Rodgers <jrodgers113@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <jrodgers113@GMAIL.COM>
Subject:      Re: 2.1L engine won't fire
Comments: To: OlRivrRat <OlRivrRat@comcast.net>
In-Reply-To:  <E60FC836-BFF6-4FDD-AD55-3D777BC26ADC@comcast.net>
Content-Type: text/plain; charset=UTF-8

It's weird. It's worked just fine for over two years since being modified. Then suddenly this malfunction. And with no warning symtoms of any kind that I could detect. My ECU MONITOR shows fuel injector pulse, hall sender pulse, and normally, the coil pulse. Now the coil light is on, but it does not pulse as it should when working properly. Will check it out sometime today. On a WBX 2.1, there are ECU's from different companies, but I surmise they all perform the same. No performance differences across the board and should be interchangeable from one Van/2.1L to another.

John

On Mar 23, 2017 01:46, "OlRivrRat" <OlRivrRat@comcast.net> wrote:

> Sounds as if Your Modified ECU May Have A Bug In It ~ > > > On 22 Mar , 2017, at 11:56 PM, John Rodgers wrote: > > No. Swapping in the first place was a pretty good task for an old crippled > guy. The reason for the swap in the first place was that the ECU in the > '88 GL was modified to use the Shoebox Monitor, which is a great little > trouble shooting tool. I needed it for tuning, It allows you to even drive > the van while simultaneously getting engine performance readouts. At this > point, I have plugged in the monitor, and I'm getting an indication there > is no coil pulse. This happened on the '88 GL one time before. One minute > it ran fine, on the next startup a few minutes later thevcoil was dead. > There was no warning, it just quit. I'll check it out when it gets daylight! > > John > > On Mar 22, 2017 22:33, "OlRivrRat" <OlRivrRat@comcast.net> wrote: > >> Kinda Curious here about Why You Switched these ECUs in the 1st >> place & Why >> >> You Did Not Immediately Switch Them Back to see if the Issue would go >> away ~ >> >> ORR ~ DeanB >> >> On 22 Mar , 2017, at 5:14 PM, John Rodgers wrote: >> >> > Two vans, both running, parked side by side. A carat, and an '88 GL. >> > SWAPPED ECU's - '88 GL starts, runs! Carat won't even fire! ECU swap was >> > all that was done. Verifide ground and connection were good. >> > >> > What say "the list"? >> > >> > John >> >> >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.