Also, I did try spreading each end of the pin but I have yet to find a reliable way to steady the work so the pin doesn't just simply move. Image shows 2nd pin installed. Obviously the end of pin has to be up against mild steel or stronger. (than brass piece shown) Thanks Neil. On 6/8/17, Neil N <musomuso@gmail.com> wrote:
> Image showing roll pin installed: https://goo.gl/photos/oKNY3UFQ2oEodJVQ8
-- Neil n Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay> |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.