Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2017, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 12 Jun 2017 11:38:35 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Rear hatch grommet update
Comments: To: "kenneth wilford (Van-Again)" <kenwilfy@comcast.net>
In-Reply-To:  <CANEuo0gLj8jsVQRNA3HPakuzZ9YstB7rqMUVz804k+2ZBnC-JA@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"

Ken, I don't do videos but I'm good with the rest if you wanted to shoot one this way.

Yrs, d

On Mon, Jun 12, 2017 at 11:13 AM, kenneth wilford (Van-Again) < kenwilfy@comcast.net> wrote:

> Eric, would you like one of the prototype of the new version of this > grommet? Email me your address again and I will send you one to test. > > Ken > > On Sun, Jun 11, 2017 at 11:38 AM, Eric Caron <ecaron1@comcast.net> wrote: > > > Hi Mark, > > > > I saw your email asking for a rear hatch grommet update. > > > > Chris from T3 wrote me and only had the oval grommet for the driver’s > > side. round ones not available anywhere as far as I know. > > > > Jim is sending me a used one but it sounds questionable. > > > > I will probably construct something. I found some round rubber pieces > > Grommets just for the holes no tube attached. I have some auto tubing > from > > wires that fits the inner diameter and I’ll try to squeeze the wires and > > tube for the sprayer through. This should be pretty tight but I’ll look > > into some gasket seal for the connection points to help with keeping > water > > out. > > > > It seems like the driver side that is available fails less often I > suspect > > that the washer tube fails in this spot for others not just mine. > > > > At the Duck recently I looked at a friends van and his had the same > > problem as mine. The driver side was perfect. the passenger side with > > round ends had failed. He coverd with rescue tape once it was > discovered. > > > > So If I find a good one I’ll hold on to it! But i’m not going to redo > > those wires and tube again once done! > > > > Eric Caron > > 85 GL Auto > > Loving the summer adventures. > > > > > > > > > -- > Thanks, > Ken Wilford > John 3:16 > www.vanagain.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.