Date: Wed, 21 Jun 2017 17:03:47 -0400
Reply-To: David Beierl <dbeierl@ATTGLOBAL.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: David Beierl <dbeierl@ATTGLOBAL.NET>
Subject: Re: Vanagon Syndrome TSB 92-02: Also Applies To Digijet ?
In-Reply-To: <CAB2RwfhxKV8o=+fhoOZ=74D_iNr=VWn7q8oHPVGcFPbQory4FA@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"
22 uF 10 volt or better (it only has five volts on it). Can't hurt, often
helps. AFM wiper to ground.
Yrs,
d
On Wed, Jun 21, 2017 at 5:00 PM, Neil N <musomuso@gmail.com> wrote:
> Much much thanks David. This will help my friends '85 I think. If need
> be I'll solder in the (22 mf ?) tantalum capacitor.
>
> On 6/21/17, David Beierl <dbeierl@attglobal.net> wrote:
> > It's yes.
> >
> > Yrs,
> > d
> >
> > On Wed, Jun 21, 2017 at 4:49 PM, Neil N <musomuso@gmail.com> wrote:
> >
> >> Hi all.
> >>
> >> Does this TSB 92-02 in the archives:
> >>
> >> http://gerry.vanagon.com/files/technical/VW-Technical-Bulletins.txt
> >>
> >> suggest that Vanagon Syndrome can happen on a Digijet equipped Vanagon?
> >>
> >> I see the upper case Digijet comment in the BTDT web page here:
> >>
> >> http://www.vanagonauts.com/Capacitor-Fix160.htm
> >>
> >> so I'm think the answer is "yes".
> >>
> >> Thanks,
> >>
> >> Neil.
> >>
> >> ------------------
> >>
> >>
> >> Technical Bulletin Group: 24 Number: 92-02 Date: April 30, 1992
> >> Subject: Vanagon Drivability Complaints Model(s): All Water Cooled
> >> Engine Vanagons SUPERCEDES TECHNICAL BULLETIN 24-92-01 (February 29,
> >> 1992) CONDITION After driving for an extended period of time at a
> >> constant speed, the vehicle may, on occasion, experience a
> >> deterioration of performance which may be accompanied by a hesitation
> >> or surging. In many cases, after turning off the engine and subsequent
> >> re-start or without having taken any action, the symptoms disappear.
> >> These symptoms may not recur for several weeks or months. SERVICE To
> >> resolve this condition, wire harness Part No. 025 906 302, should be
> >> installed. This harness provides improved signal voltage
> >> stabilization. * remove electrical connector from air flow sensor *
> >> install wire harness, Part No. 025 906 302, between main harness
> >> connection and air flow sensor connection.
> >>
> >> --
> >> Neil n
> >>
> >> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
> >>
> >> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
> >>
> >> 1981 Westfalia "Jaco" Images, technical
> >> <http://tubaneil.googlepages.com/>
> >>
> >> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>
> >>
> >
>
>
> --
> Neil n
>
> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
>
> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
>
> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>
>
> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>
>
|