Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2017, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 21 Jun 2017 22:07:32 -0700
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: Minor fridge mods addendum
Comments: To: Ed McLean <email99@BELLSOUTH.NET>
In-Reply-To:  <vanagon%2017062200133765@GERRY.VANAGON.COM>
Content-Type: text/plain; charset=us-ascii

Thanks ed, I got your pmail and replied.

I will try again to get the fin assembly detached from the pipe. And if, i mean when, i succeed I'll post pics.

I was just guessing about heat gun helping. It might , I'll see

Alistair

> On Jun 21, 2017, at 9:13 PM, Ed McLean <email99@BELLSOUTH.NET> wrote: > > I can't read steve meassick's messages because I only read from the > archives so I don't know what was said about using the heat gun. I've > not found a heat gun to be be necessary. The interior fins simply snap > on the cooling pipe. The fins can be twisted to break them loose and > then pulled off starting from the right end. The right end goes of the > cooling pipe goes through the back wall of the box and is supported > better than the left. It doesn't take a lot of force to remove the > fins. > > The modification I made was to remove the open section of fins and > replaced them with a section of cast aluminum cooling fins from an old, > old computer. This was similar to the original cooling unit but added > more net surface area for heat transfer. That modification, along with > a small fan and some thermal paste from Radio Shack (remember them?), a > couple of additional fans in the rear to remove heat and some insulating > of the chimney unit resulted in a refrigerator that actually works > pretty good in cool weather but still not so well in the Summer. > > > > On Wed, 21 Jun 2017 18:16:03 -0700, Alistair Bell <albell@SHAW.CA> > wrote: > >> It wouldn't budge and I didn't think of using heat gun. Will get around > to it. >> >> Alistair


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.