Date: Thu, 20 Jul 2017 14:30:24 -0700
Reply-To: Stacy Schneider <vwcrewman@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Stacy Schneider <vwcrewman@GMAIL.COM>
Subject: Re: vent wing frame removal
In-Reply-To: <CAPb9TKzsD=X38dpZ6YM8vYMv+aeTjStfPTy3kjpp5gnpcU8joA@mail.gmail.com>
Content-Type: text/plain; charset=us-ascii
Pull the upper top and back channel out, pull the inner and outer scrapers off( the area where your arm rests) there are clips inside the door which hold the scraper, at the front next to vent pull the 2 nearest the vent out as you will need the room. At the top of the door above the vent is a small Phillips sheet metal screw, remove it.
Pull the door panel and locate the 2 bolts that hold the door glass to the regulator and remove them. There is a sweet spot in the door where the door glass will lift out. It involves lifting the front and tilting the rear. Take the door glass out ( You can not take the vent out with the door glass in place) .
There is a single 10mm bolt at the face of the door which holds the lower part of the vent, remove that, grab a hold of the assembly and tilt it backwards and manipulate it out of the door. I should have asked if this is an early van with Chrome in the doors, if so you have to remove the rubber lip which locks into the trim before you remove.
As the English service manuals say " install is the reverse of the above procedure.
Stacy
Sent from my iPhone
> On Jul 20, 2017, at 2:02 PM, Thomas Casal <thomas.casal@GMAIL.COM> wrote:
>
> The entire assembly. The unbent frame the body shop installed is working
> perfect I'm so mad I didn't have my used parts guy ship me a straight one
> asap. This van is full of lessons.
>
>> On Jul 20, 2017 3:57 PM, "Marc Perdue" <mcperdue@gmail.com> wrote:
>>
>> Ugh, it's a pain. I tried to use Stacy Schneider's method on mine, with
>> vent glass installed. Not sure how to describe it at this point though, nor
>> that I would. Mine leak and my windows don't go up and down easily; they
>> start up at an angle, I pull them straight by hand, then continue rolling
>> them up.
>>
>> Marc Perdue
>>
>> On Thu, Jul 20, 2017 at 2:02 PM, Thomas Casal <thomas.casal@gmail.com>
>> wrote:
>>
>>> Hello Good People,
>>>
>>> I had my van painted and I purchased better used vent wing frames that the
>>> body shop installed. One of the wings was slightly bent in shipping I
>>> figured it would still work if the holes lined up and they did but now the
>>> wing doesn't seal properly its hard to roll the window up and it leaks
>>> when
>>> it rains. So I have another wing coming and I'm fairly mechanical. All
>>> the information I've found online nobody actually removed the vent wing.
>>> Does anyone know the proper procedure to remove the vent wing? Thanks for
>>> any and all advice. peace tom
>>>
>>
>>
|