Hi, I am rebuilding my entire camper interior (everything is out already). I was thinking to change the veneer of the big wooden panel , the biggest one which lay on the driver side and goes from the water tank to the driver seat. While looking at home depot, I notice this big fiberglass sheets class c for $30 which could easily replace the wooden panel. it is resistant to mold. It seem to have the same flexibility and thickness. Replacing the whole panel will also allow me to fill in the hole behind where was the fridge. Did any one did that ? What about using fiberglass class c in the van: Pro and cons , temp resistance, fiberglass degradation over time , ... ?
Thanks for any tip .
Chris, |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.