Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2017, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 31 Jul 2017 06:37:38 -0700
Reply-To:     Don Hanson <dhanson928@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson928@GMAIL.COM>
Subject:      Re: Magnets and Vanagons
In-Reply-To:  <CAFnDXk2GY+S+tehcy1bDQWGrVUBVdTyhkdR95wv2PdSAa4cuWg@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"

I got 2 dozen small strong ones living in my faux-westie tin top. 1/8" thick x 1/4" wide x 1/2" long. Some are sewn into the hems of my curtains, they hold notes on my dash,, I made a magnetic phone holder, all kinds of uses in a mostly metal Vanagon...

On Jul 31, 2017 4:52 AM, "Jim Felder" <jim.felder@gmail.com> wrote:

> At Felder Industries we buy welding ground magnets where the freight > arrives at our Harbor and drill and tap them to accept 12v dash fans. After > an application of felt on the bottom they can be used almost anywhere in a > metal-dash Westy. > > Jim > > On Sun, Jul 30, 2017 at 11:17 PM Alistair Bell <albell@shaw.ca> wrote: > > > One of those fabric reinforced Mylar faced "space blankets" a couple of > > rocks or tent pegs holding bottom of blanket out from van, magnet holding > > top of blanket either above or below kitchen sliding window, and you have > > shade for the fridge side of van. Be sure not to block fridge exhaust. > > > > Alistair > > > > > On Jul 30, 2017, at 7:28 PM, Eric Caron <ecaron1@COMCAST.NET> wrote: > > > > > > Hi folks, > > > > > > For some time I had a battle with a led light I wanted mounted > > over the bed over the engine compartment. I don’t like drilling wholes > > when I can avoid it so I used velcro. the light was handy for folks > seeing > > the back area at night or for night view of the engine compartment. The > > velcro adhesive refused to stay connected to the roof. > > > > > > Today I took a strong magnet a 1.5 inch disk. I placed it in > the > > upper storage area above where I wanted the light to be mounded. I > > attached a magnet to the led light and perfect, it stuck firmly to the > > ceiling and no drilling or adhesive needed. I can even easily remove the > > light use it somewhere else and then it snaps back in place like > magic. I > > duct taped the upper magnet in place. > > > > > > Any other creative vanagon magnet ideas out there? > > > > > > Eric Caron > > > 85 GL Auto > > > P. S. > > > I may not be able to see but I make sure those camping with me can! > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.