I usually break the plastic welds with a pair of vise grips (grab and rock back and forth until they snap off), then go around with a large flat head screw driver and pry around until all of the welds break. Use metal clips to put things back together. Ken On Wed, Sep 6, 2017 at 3:16 PM, Robert Ueltzen <robueltzen@gmail.com> wrote: > Any suggestions on how to separate the two halves of the housing. Mine is > glued. Did you use an exacto knife or a dremel tool with cutting disk? Or > does the glue release with enough leverage (which I am afraid to try)? >
-- Thanks, Ken Wilford John 3:16 www.vanagain.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.