Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2017, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 6 Sep 2017 20:40:09 +0000
Reply-To:     "Jim. Felder" <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Jim. Felder" <jim.felder@GMAIL.COM>
Subject:      Re: Splitting the ventilation housing
Comments: To: "kenneth wilford (Van-Again)" <kenwilfy@comcast.net>
In-Reply-To:  <CANEuo0grYn4rh4mAKpVMhyYCK=AnUWXwD_D-+O9=MhXFiCdRdw@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"

Ive done it many times with a hammer and putty knife. Start in a corner and go around.

Jim

On Wed, Sep 6, 2017 at 2:29 PM kenneth wilford (Van-Again) < kenwilfy@comcast.net> wrote:

> I usually break the plastic welds with a pair of vise grips (grab and rock > back and forth until they snap off), then go around with a large flat head > screw driver and pry around until all of the welds break. Use metal clips > to put things back together. > > Ken > > On Wed, Sep 6, 2017 at 3:16 PM, Robert Ueltzen <robueltzen@gmail.com> > wrote: > > > Any suggestions on how to separate the two halves of the housing. Mine > is > > glued. Did you use an exacto knife or a dremel tool with cutting disk? > Or > > does the glue release with enough leverage (which I am afraid to try)? > > > > > > -- > Thanks, > Ken Wilford > John 3:16 > www.vanagain.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.