On 10/1/17, Neil N <musomuso@gmail.com> wrote: > My guess is that the green O2 coax is shorting out. Remove the > connector to the green coax, engine off, use voltmeter to check if > theres any continuity between the centre lead and outer coax. As an alternate to sliding the rubber cover on that green coax back (to expose outer shielding strands) put meter probes between green wire centre wire and clean ground point. Again, NO continuity should be seen. Neil.
-- Neil n Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay> |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.