Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2018, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 27 Mar 2018 09:45:28 -0600
Reply-To:     OlRivrRat <OlRivrRat@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         OlRivrRat <OlRivrRat@COMCAST.NET>
Subject:      Re: Fuel tank problem solving (Almost)
Comments: To: Cunegonde <cunegonde.van.westfalia@GMAIL.COM>
In-Reply-To:  <9E1E0D9F-4B40-409A-A514-D17C1A9D6DF5@gmail.com>
Content-Type: text/plain; charset=windows-1252

Turn the Igni'Key to "On" (Not Start) then "Off" about 10 to 15 times to try to

get the Pressure Up & then try to Start ~

On 26 Mar , 2018, at 2:35 PM, Cunegonde wrote:

> It’s a $2 hose failure. > > When I blew CO2 into the supply/pump side spigot, all I heard was a whooshing noise. Not gurgling, similar to fish tank aerator bubbling sound. Hmmm, was the intake screen detached from its base and above fuel level? But why does the tank seem empty when I tap on it? I filled it just before the problem started! > > Planning to switch intake for return fuel lines in hopes of getting enough fuel flow to start the van, I detached the fuel pressure return line at the driver’s side tank spigot. Hose comes off in my hand as soon as I pull on it. A tiny dribble of gas comes out the return line, but nothing on the spigot end. Yep, the the tank’s empty because all the fuel dumped out while I was driving! No wonder the van wouldn’t run. > > I replaced the 8” 7mm ID hose at the return spigot, with new fuel line and stainless hose clamps. The engine fuel pressure return line is a rigid plastic 7mm OD hose that slips into the 7mm ID connector hose. Is this standard? > > I put 5 gallons of gas in the tank. Checked for fuel flow at both spigots. Yes, fuel from both sides. Tried to start car - I can hear the pump running but it doesn’t stop as it should when there’s sufficient fuel pressure. Car turns over but won’t start, presumably no fuel at the engine. I assume the fuel pump is damaged from running dry for too long? > > I detached the pressurized fuel line after the pump. No gush of pressurized fuel as I would expect, just a teaspoon or two from the engine side of the line. > > So next is a replacement fuel pump, or other suggestions?


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.