Date:         Tue, 22 May 2018 17:37:23 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Bentley question regarding Idle Speed Stab. valve
              troubleshooting
Comments: To: Pat Spragge <spraggepat@gmail.com>
In-Reply-To:  <FFA8B7F2-60F9-40DD-8E5D-DD9839A33107@gmail.com>
Content-Type: text/plain; charset="UTF-8"

>
> I was going to perform the 2nd check “regulator”, however I am unsure
> about the step where one connects the multimeter with adapter to idle
> stabilizer valve #1 in the photo. Problem is the photo shows the O2 sensor
> and not the valve.
>

Put your meter in series with the valve.  The connector is a three-pin
version of the Bosch-type fuel injector connector.

Yrs,
d

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.