While poking around in advance of changing out my rotors and pads, I noticed that I have some rust on some of my hard braked lines. So now I figure I should change those too. So far I have only seen rust on the rear lines, where access doesn't seem to bad. I'm assuming the worst lines to change are the ones that actually go to the master cylinder.
Any thoughts on sticking with a partial replacement? Apart from obviously being less work, this means a lot fewer disturbed fittings. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.