Date:         Thu, 9 Aug 2018 13:38:11 -0700
Reply-To:     Stuart MacMillan <stuartmacm@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stuart MacMillan <stuartmacm@GMAIL.COM>
Subject:      Re: temp gauge not working right...
Comments: To: Dan N <dn92610@GMAIL.COM>
In-Reply-To:  <CAFdLW6mFS=1fJ1WAy3Xr=t3Dx1hdM=K26aSY_A5X0pAm-1_F6w@mail.gmail.com>
Content-Type: text/plain; charset=us-ascii

You could cut it a couple inches from the connector and run a wire to any convenient spot on the chassis. Just use a crimp butt connector.

Stuart

> On Aug 8, 2018, at 6:25 PM, Dan N <dn92610@GMAIL.COM> wrote:
> 
> Pat, I change all of them, the one for the ECU and the one for the coolant

> gauge and the coolant level sensor too... because the van was neglected for
> at least a year...
> 
> thanks

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.